This commit is a patch to address the issue of the Twist v1.1.2 board whose HRTIMA signals have been inverter in routing.

This commit defines a new hardware version, the TWIST_V_1_1_2.
This hardware version is then used to set up the control initialization sequence of the power legs, applying the necessary changest to leg 1 whose timer signals have been reversed in routing.
There is also a correction on the hrtim_init_independent_mode functino that initializes the pwm_phase_shift variable as well as their leg dependent equivalents.
This initalization is necessary to use the hrtim_interleaved_pwm_update function which uses the phase_shift variable when updating the duty cycle of interleaved buck and boost applicaitons.

This merge request corrects a small glitch on the trigger for the ADC for the O2 board.

This was changed some time ago. It did not work when tested in practice.

- The ADC 2 event necessary to trigger conversion was wrongly set for the spin board and measurements were not working.
- The gain and offset functions for V2 and i2 were not writing at the correct place on the gain table

Luiz Fernando Lavado Villa authored 2 years ago and Jean Alinei committed 2 years ago

The old version of the SPIN board required inverting the RX/TX of the serial port. The new version does not need this inversion.

This commit corrects a bug on the board version and allows choosing the correct SPIN version.

Clément Foucher authored 2 years ago and Luiz Fernando Lavado Villa committed 2 years ago

Provide a new communication API that rely on Thingset over CAN.
As the module relies on a third-party module that has to be downloaded, it is not enable by default.

The HRTIM still lacks some functions needed for a fine management of the PWM generation. This PR adds several functions. 

Deadtime management
The deadtime can now be managed separately from the rising and falling edges.

Phase shifting
The phase of the second leg can now be updated dynamicall

Bug fixes: 
Readable Independent mode
The independent mode can now be set as buck or boost instead of true or false, making it more readable.

Extra features: 
There is now a board version support for the SPIN board

Ayoub Farah Hassan authored 2 years ago and Clément Foucher committed 2 years ago

Rewrote hrtim driver with LL APIs. Added Up-down mode (center aligned PWM) for buck, boost and independent mode. Corrected initialization errors for independent mode.

Add capability for finer configuration of HRTIM ADC event generation; Separate event generation postscaler.

Add ability to set discontinuous mode on ADCs; Add support for various trigger sources from HRTIM to ADCs.

New device tree organization, not based on Nucleo dts.

Update error codes.

Update NGND drive to use new Zephyr GPIO API.

Align device tree defines to ***_DEVICE nomenclature.

Integrate data conversion into the data acquisition module.